Speedwatch Knotmeter
Model:
knotmeter
SKU: DSD465963
The easy way to measure your boat's speed! JDC's NEW Speedwatch wireless knotmeter is a breakthrough in ease of
installation and features. NO wires! NO holes! Mount the impeller under
the boat and place the transmitter inside the boat. That's it! Instant
speed is transmitted to the display anywhere in the boat, up to 13 feet
(4 meters) away. Just as easy to use on your kayak as your
sailboat.
Unlike GPS, which measures speed over land, the SPEEDWATCH measures
your actual speed and distance through the water.
FEATURES:
Easy to install: fix the impeller on the water with 1 of the 3 included
fins, place the radio transmitter inside the hull and that's all!
Magnetic transmission through the hull without hole (JDC patent) and
radio transmission to the display unit (over four meters)
Current speed
Balanced speed (set by customer)
Average speed of the trip (hundredth of unit)
Maximum speed reached
Display of speed increase or decrease
Distance of the trip
Global distance traveled (over one season)
Units: km/h, m/s, knots and mph
Automatic or manual chronometer
Programmable countdown timer for regatta start
Clock
Waterproof
Possibility to use the existing paddle sensor of your boat
Calibration possible to match any kind of speed sensor
Possibility to fix the display anywhere on the boat and also for each
crew member to have his own display unit
Backlight
Low power consumption (around 20'000 km sailed without changing battery)
Velcro strap
Low radio frequency (8,2 kHz)
Min. speed reading: 0,3 knots, 0,5 km/h, 0,1 m/s, 0,3 mph
Advantages over GPS:
While the SPEEDWATCH does not replace a GPS, it does have many
advantages when training and monitoring performance:
- Instant speed
- Actual speed through water
- Registers speeds down to 0.3 mph
- Tracks acceleration
- Countdown timers specific for regattas
- Long battery life
- Total and trip distances
Using the SPEEDWATCH during training, one can instantly gauge the
effect of different paddling strokes, equipment, and sailing techniques,
enabling the best performance possible.
The Impeller:
The impeller is mounted under the boat, attached via a fin or clip
mount. The small impeller - slightly more than an inch long, spins
through the water, in speeds from 0.3 mph (0.3 knots, 0.5 km/h) to over
40 mph (35 knots, 64 km/h).
When the impeller spins, a magnetic field is created which is
measured by the transmitter - through a hull - up to 12 in (30 cm) away.
NO wires connect the impeller to the transmitter! This magnetic
transmission is patented technology by JDC Electronic.
The Transmitter:
The transmitter is placed inside the boat, within 12 inches (30 cm) of
the impeller. The transmitter picks up the impeller's magnetic field
when it is rotating, transmitting the data over 8.2 KHz up to 13 feet (4
meters) away.
The transmitter is water-proof, with a replaceable lithium battery.
good for 12,500 (20,000 km) of readings. The transmitter can also
receive other speed sensors and transmit to the display, which can be
calibrated to properly display the speed and distance.
The Display:
The SPEEDWATCH display contains an internal receiver to pickup the
information sent by the transmitter, up to 13 feet (four meters) away.
The display shows instant and average speeds, distance traveled, trip
distance, acceleration, time traveled, and chronometer and countdown
timers.
The SPEEDWATCH will be an essential tool for training, providing
instant feedback on speed and acceleration. Unlike GPS units, the
SPEEDWATCH gives true speed through water and distance traveled, versus
speed over land. When going against a current, the speed given by a GPS
unit will be very inaccurate.
The SPEEDWATCH display can be mounted on a deck or strapped to a
wrist or leg. Multiple displays can be used with one sensor . Powered by
a lithium battery, the display is water-proof and will register up to
12,500 (20,000 km) on one battery.
Dia: 3.0 in (78 mm) X .70 in (18 mm), Weight: 3.5 oz (100 g) |

$249.95
|